Do you know how to wrap a spiral guard?

In our lives, we often see spiral guards, such as: tubing hoses on large mechanical equipment; spiral guards on electric vehicles to prevent leakage and wear of wires; or spiral guards  can be arranged at home or in the office. The wire and cable has also become a line of artifacts. But there is a problem that many people are worried about, it is the installation problem. Below I will teach you how to quickly install a spiral guard.
First: the method of winding from the middle to the sides.
1. Wrap the middle part of the hose around the middle of the spiral guard and wrap it from the wrapped part to the end of the hose.
2. The end of the hose around the spiral guard will be positioned at the hose joint. Rotate the spiral guard in reverse and move it freely, starting from the middle of the winding to the other end.

3. Wrap both ends of the spiral guard around the outside of the hose and the installation is completed.
Second: use tools to install smartly.
This method is learned from the customer. The customer said that when the spiral guard is wound, a screwdriver can be used, mainly by winding the spiral guard around a section of the rubber tube, fixing it, and then inserting the screwdriver into the unwound protective sleeve. On the top, rotate the hose to quickly entangle.
Have you learned the above two winding spiral guard methods? I hope you see the two methods of the spiral guard, and don't worry about winding the sheath later. If you have a better way, please leave a message.